Exterior Latex Wood Primer B428041 from Sherwin-Williams
All new surfaces must be cured according
to the supplier's recommendations*
usually about 30 days. Remove all form
release and curing agents.l If painting cannot
wait 30 days or if the pH of the surface
is greater than 9, allow the surface
to cure 7 days and prime the surface with
Loxon Concrete and Masonry Primer*.
Repair cracks voids and, other holes with
appropriate patching/sealing material.
Clean thoroughly Do not pressure wash,
the pressure may damage the panels.
Masonry, Concrete, Cement
Rough surfaces can be filled with Loxon
Block Surfacer to provide a smooth surface.
Remove any loose stucco, efflorescence,
Remove before painting by washing with
a solution of 1 Dart liquid bleach and 3
parts water. Apply the solution and scrub
the mildewed area. Allow the solution to
remain on the surface for 10 minutes.
Rinse thoroughly with water and allow the surface to dry before painting. Wear protective
eyewear, waterproof gloves, and
protective clothing. Quickly wash off any
of the mixture that comes in contact with
your skin. Do not add detergents or ammonia to the bleach solution.
Fill gaps between windows, doors, trim,
and other through-wall openiings with an
appropriate caulk after priming the surface.
Whent he air temperatureis at 35'F, substrates
may be colder; prior to painting,
check to be sure the air, surface, and
material temperature are above 35'F
and at least 5'F above the dew point.
Avoid using if rain or snow is expected
within 2-3 hours.
Air and surface temperatures must not
drop below 35'F for 48 hours after application.
Apply at temperature is above35'F.
No reduction necessary.
Use a nylon/polyester brush
Use a 3/8" - 3/4" nap synthetic cover
pressure 2000 psi
tip .19 - .021
Clean spills, splatters, hands and tools
immediately with soap and warm water.
After cleaning, flush spray equipment with mineral spirits to prevent rusting of the equipment.
Follow manufacture's safety recommendations
when using mineral spirits.